mass production

[Marco Pennacchietti]

for the mass production what is the best solution in order to flash the nRF52?

for the mass production can I use DK PCA10040 ?

The DK PCA10040 can be used for dubbug on my the target ?

For flash and debugg on my target I need only to connect SWDCLK, SWDIO, GND ?

Thanks

Marco

[Sigurd]

Hi,

For production programming we have a infocenter page here you should take a look at. We also have a more detailed whitepaper here.

---

Summarized:

You have two options when programming for production:

1. In-system programming (ISP): ISP is used when programming is needed after the assembly of the final PCB. Here we recommend using a SEGGER Production Programmer.

2. Socket programming: Socket programming is used when the SoC is pre-programmed before it's mounted on a PCB. Here we recommend using a production programmer from either Elnec or Hi-Lo systems.

Note that the license for the J-Link OB programmer on the nRF52 DK does not allow it to be used as a production programmer. See this post for more information.