light switch example : configuration not happening

[Arij]

Hi

I'm facing a problem with light switch demo from mesh SDK v1.0.1, when running the light switch client, as shown in the rtt viewer below the configuration of the server doesn't happen even though i can switch on and off the server, i don't understand how it works even the server is not configured, i only modified the server_count to 1 and still not configured

I have 1 client and 1 server and working on nrf52832 boards

Here is the rtt viewer on client side 

and the server side

Any help please ?

Thanks in advance

Arij,

[Hung Bui]

Hi Arji, 

 

Please try again with the latest SDK v2.0.1 , it's much more robust. 

[Arij]

Thank you for your reply, I tried with SDK v2.0.1 and it works fine, i have 1 client (nRF52832),1 provisioner(nRF52832) and 1 server (custom board), i don't have enough boards to test the relay feature unfortunately, so i'm trying to solve this problem with SDK v1.0.1

[Hung Bui]

I'm not sure what you mean by "not enough board to test the relay feature"  ? You can use the provisioner as the middle node to relay the message from client to server.

 

On SDK v1.0.1 you would need 3 servers and one client before the set-up start to work. With SDK v2.0.1 you just need at least one server. 

[Arij]

Yes you are right, i forgot that a node can act both as a provisioner and a server or a client,

Thank you for your reply