This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Setup and environment to connect PCA10040 with Linux based system

Hi all,

I am using a linux based board and wanted to support BLE5.0 on that board. PCA10040 is connected with My board through UART. Please forgive me for these basic doubts. 

I have doubt regarding these things. 

1) If I need to send some command from my linux board to nRF52832, how can I make communication and what will be frame format?

2) Will it be possible to flash the HEX file from My board via some command? Currently, I am flashing firmware on the device with the help of nRFGO Studio.

3) If I want to store some profile on BLE device, Can I send some commands from my Linux board? 

Thanks,

Ashish Agrawal 

Related