This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

After entering into Standby-II state, how can 24L01+ change state to Standby-I?

Based on the nRF24L01P Product Specification 1.0, after 24L01+ enters into Standby-II state, the only 2 ways to leave this state are 1, set PWR_UP to 0, 2; 2, Feed data into TX FIFO. 

Can I set CE to 0 to change the state to Standby-I, and set PRIM_RX = 1 and CE to 1 again to make 24L01+ enter "RX Setting 130uS state"?

thanks in advance. 

Related