• State Verified Answer
  • +1 person also asked this people also asked this
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 87 subscribers
  • Views 2208 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 208518
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Direct Test Mode

oneguy

Hi 

I wonder if the SDK DTM example can be used with a Rhode & Schwarz CMW500 unit. Are the commands compatible with each other, i.e. expected by the CMW500 and DTM example ?

Thank you for your reply

Matthias

Parents
  • +1

    Hi,

    We are mostly familiar with the Anritsu tester, and we have a whitepaper for that here. But the CMW500 should also work, and we have seen it used successfully by others doing DTM testing on the nRF5 before. These testers contain quite a few ways to set this up, so make sure to configure the tester for 2-wire UART, and that the firmware is up to date on the tester.

Reply
  • +1

    Hi,

    We are mostly familiar with the Anritsu tester, and we have a whitepaper for that here. But the CMW500 should also work, and we have seen it used successfully by others doing DTM testing on the nRF5 before. These testers contain quite a few ways to set this up, so make sure to configure the tester for 2-wire UART, and that the firmware is up to date on the tester.

Children
Related
Terms of service