smart remote add on dk

[pksk]

Hi team,

Today i received smart remote 3 kit.

one ready remote and other one is add on remote.

I can be able to update the firmware to using debugging pins to ready remote(via nrf52dk) and can able to pair with my lap top and operate. but once i disconnect it from lap top and started scanning then my remote is not advertising. so which button we need to press to enable the advertising once it disconnected.? it is advertising if i flash the firmware again.

and also i have add on dk board iam not getting how to operate that ? how to flash firmware ?how to enable advertise? i gone through user guide but not helped much. so please help on the same.

cheers

pk

[Jørgen Holmefjord]

Hi,

If you have paired (bonded) the smart remote with a device, it will do directed advertising towards this device and go to sleep after a short period of time. You can delete bonding information as desctibed in the Pairing Quick Start documentation.

In order to program the DK add-on board, you need to assemble it as described in the two first sections of the Quick start docuemntation. The firmwares are available for download on the product page. The firmware package contains projects for Keil  IDE and GCC compiler.

Best regards,
Jørgen

[pksk]

Hi,

Also i am using ready product example , how should i delete the previous bonding information and make it advertise again.

document says press the button during power on but that applies to ad on dk, not with ready product example .

please confirm.

pk

[Jørgen Holmefjord]

Same procedure, remove batteries, hold button, put batteries back in while holding button.