This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Optimization of the current consumption of the Central device

Hello everybody,

I am using central device with SDK14.2 and S132.  

In a central application, the operation sequence is as follows:
* Buttons pressed and scan started
* Connect and LED on if the desired peripheral device is found
* Send a nus_data with 3 characters after connecting
* Disconnect and enter standby mode.

The process is successful but the current consumption is max 13mA during the connection. When entering Stanby mode, it consumes about 1.8uA of current (as it should be). Is there a way to reduce the current consumed during the scan start and connect times?

Note: The LED consumes 0.6uA.

Parents Reply Children
Related