• State Verified Answer
  • Locked Locked
  • Replies 2 replies
  • Subscribers 67 subscribers
  • Views 1307 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 103590
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

fab house in EU?

Oleh

Dear all,

we're at the pre-production stage, I would like to ask here in the forum the suggestion and/or your experience with fabs in Europe.

What we are looking for?

  • a fab for fast turnover prototypes
  • a production fab as well

especially for Germany and Italy as our locations are in these two countries, but of course not limited to those.

Also, is it common if you ask a fab BGA+Balun assembly to answer they cannot prototype but could to production? I was expecting either clear no or do-both, am I wrong?

Thank you

  • 0

    I've used Sub Assembly Services in the UK a number of times with excellent quality & service. Pricing is good for the UK but might be higher than in Italy (just guessing).

    It's not too strange to not be able to prototype BGA, as you need special equipment for placing them for prototypes (Or you'd have to eat the cost of setting up the pick&place machine) and preferably an X-Ray machine to test whether they made good connection. For production you would set up a proper test setup and use a pick&place machine (And you can "dial in" the production process to get a good yield).

  • 0 in reply to Janek Mann

    Dear Janek,

    thank you for your share! I'll check them, thanks! Oleh

Related