This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NC pin may be used for PCB trace routing?

aaronxu over 10 years ago

Hi,

Continue nRF51822 WLCSP Reference Design No Connection Pins Tied to Ground,NC pin may be used for PCB trace routing?

Thanks, Aaron

0 Asbjørn over 10 years ago

Yes, the NC pins on the nRF51822 WLCSP may be used for trace routing. The NC pin must be soldered onto the PCB for mechanical reason however, but if it's a floating pad or a signal doesn't matter.
Cancel
Vote Up 0 Vote Down

Cancel
0 aaronxu over 10 years ago in reply to Asbjørn

Thanks! Besides, how to accept this?
Cancel
Vote Up 0 Vote Down

Cancel
0 Petter Myhre over 10 years ago in reply to Asbjørn

Click the grey circle with check mark in it.
Cancel
Vote Up 0 Vote Down

Cancel

Related