This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF Connect Programming PCA10059 issue

I am quite confused about how to go about programming the nRF52840 Dongle. The "programming" page on infocenter says that it can be programmed through the nRF Connect Programmer Application.

It seems that I can program soft devices with no issues. But when I try the blinky_pca10059_mbr.hex, I'm getting the "DFU Failed. Reason: Too many write failures" error.

Can you please guide me in programming the nRF52840 Dongle?

Top Replies

Michael over 6 years ago in reply to Martin Lesund +6

Hi Martin Could you if possible explain the process needed to take an existing PCA10056 project and convert it for the PCA10059 board so that it can be programmed via the bootloader/DFU ?? Cheers …
Martin Lesund over 6 years ago +2

Hi Ashwin, - Note that the "Programmer" app in nRF Connect for desktop is still in experimental stage, so some inconsistencies may be experienced. The nRF52840 dongle does not have a programming chip…

0 Martin Lesund over 6 years ago in reply to Michael

Hi Mike,

I would suggest that you make a new thread about the last question.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel