• State Suggested Answer
  • +1 person also asked this people also asked this
  • Replies 7 replies
  • Answers 2 answers
  • Subscribers 65 subscribers
  • Views 5756 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 212096
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

How to test Mesh using nRF52840 Dongle

Alan Ajit

Dear Nordic,

I bought three nrf52840 dongle.

How i test the mesh i am totally confused how its programmed and how mesh tested with this nrf52840 dongle can you help me to testing mesh with nrf52840 dongle and programming this Dongle

Parents
  • 0

    Hi,

    Have a look at this User Guide on how to program and use the nRF52840 Dongle. The dongle is the preferred hardware to be used with the nRF Connect for Desktop and can be used with nRF5 SDK for product development. But unfortunately, the Mesh SDK does not support the nRF52840 Dongle(PCA10059) as of now. You will need a development board to test the Mesh SDK. You can see which board are compatible here.

  • 0 in reply to Mttrinh

    Hi,

    Yes, it is possible to program the dongle using the DK.

    On the DK there is a connector called Debug Out. You need a 10 pin segger cable that fits there, then connect this cable from the DK to the P1 pin headers. You would have to solder the programming pins on P1 (on the bottom side of the dongle). 

    Have a look at this post for more detailed information regarding programming the dongle.

Reply
  • 0 in reply to Mttrinh

    Hi,

    Yes, it is possible to program the dongle using the DK.

    On the DK there is a connector called Debug Out. You need a 10 pin segger cable that fits there, then connect this cable from the DK to the P1 pin headers. You would have to solder the programming pins on P1 (on the bottom side of the dongle). 

    Have a look at this post for more detailed information regarding programming the dongle.

Children
No Data
Related