Dear Nordic,
I bought three nrf52840 dongle.
How i test the mesh i am totally confused how its programmed and how mesh tested with this nrf52840 dongle can you help me to testing mesh with nrf52840 dongle and programming this Dongle
Dear Nordic,
I bought three nrf52840 dongle.
How i test the mesh i am totally confused how its programmed and how mesh tested with this nrf52840 dongle can you help me to testing mesh with nrf52840 dongle and programming this Dongle
Thank you Mttrinh,
Document says Dongle can program using programmer programming app or nrfutil
I tried to program dongle using DK board through programming interface(refer from hardware manual) but its not flashing. Is it possible to program dongle using DK board? or any other app support programming dongle
Hi,
Yes, it is possible to program the dongle using the DK.
On the DK there is a connector called Debug Out. You need a 10 pin segger cable that fits there, then connect this cable from the DK to the P1 pin headers. You would have to solder the programming pins on P1 (on the bottom side of the dongle).
Have a look at this post for more detailed information regarding programming the dongle.