Hi ,
I search nrf52810_bitfields.h , but i don't find about start bit , is the direction search for error ?
My idea : This is set up for stop bit , should the start bit be the same?
Hi ,
I search nrf52810_bitfields.h , but i don't find about start bit , is the direction search for error ?
My idea : This is set up for stop bit , should the start bit be the same?
Hi,
There is no configurable amount of start bits for the UARTE peripheral. The CONFIG_STOP register is used to control if 1 or 2 stop bits should be used.
Best regards,
Jørgen
There should always be 1 start bit in the frame, you don't need to configure this.
You should be right.
Because I sent DMX512 (similar to RS-485), the device responded, although it was not the result I wanted.
Another article I published, can you help me, please?
https://devzone.nordicsemi.com/f/nordic-q-a/37726/send-uarte-data-but-an-error-has-occurred
One of my colleagues will help you with your other question.
One of my colleagues will help you with your other question.