Cannot discover device using master control panel

[Frank Zhao]

I have a nRF51822 dev kit, and my dongle is running the master emulator firmware, and master control panel is running on my computer, the dongle is connected and started discovery mode without any problems

I have one of my PCA10004 boards programmed with "s110_nrf51822_6.0.0-1.alpha_softdevice.hex" from 0x00 to 0x14000, and "ble_app_advertising" example from 0x14000 and onwards (compiled under Keil)

I expect to see a new device become discovered in master control panel. But I do not.

What am I doing wrong?

[Frank Zhao]

Hi Sebastien

Thanks for the reply

The nRFgo Studio software is pretty clear on which Segger J-Link was used. But I did try again after disconnecting the PCA10000 dongle, then reflashing the PCA10004. Still nothing being discovered.

Note: I can run DTM in transmit mode, and see appropriate spikes on my spectrum analyzer (a RF Explorer, nothing fancy), so the radio is working...