nRF52840 2nd and 3rd harmonic out of spec

[Johannes]

Hello!

We're building radio modules with the nRF52840, one with the a frontend amplifier and one without. Both are exhibiting excessive 2nd and 3rd harmonic emissions.

We're trying to narrow down the source of these harmonics and in doing so we tested the nRF52840dk devkit. Running a simple firmware that generates a carrier at channel 80 with random data, and configuring the radio to output 8dBm we measure about 4.4dBm for the 1st, -48dBm for the 2nd, and -40dBm for the 3rd harmonic. Measurements were done over coax cable.

The datasheet specifies -51dBm for the 2nd, and -48dBm for the 3rd harmonic, "in IEEE 802.15.4 mode". Is there a maximum specified anywhere? Or something that's related to the output signal power?

There could be some slight mismatch in our cabling but it shouldn't result in an 8dB difference, right?

Is this behaviour according to spec or are we either measuring it wrong or interpreting the specification wrong? I'd appreciate any kind of insight.

See screenshots for details:

[Johannes]

Hello Andreas,

Yes, the devkit is without a frontend. It has a sticker on it saying "nRF6828 rev 1.0.0  2018.21".

We're currently investigating all possible sources, and yes, the frontend is high up on our list of suspects, as is production variances in our matching network.

But regardless, the devkit should perform according to spec, right?

I'll redo our measurements with RMS detector and update with the results.

You mention that the harmonic generation is not as agressive on lower power settings. We're also operating on that assumption, but it would be nice to have some characterization or specification of how much it drops on lower output powers.

Best regards,

Johannes 

[Andreas]

Hi Johannes,

 

The devkit should perform according to spec, yes. There will still be some variation as you say, do not count on every board hitting the typical dead on.

In 0dBm 2H is typically ~-70dBm, 3H ~-60dBm conducted.

 

Best regards,

Andreas