nRF Thread Topology Monitor source code

Question

Hello, 
 Is the source code of nRF Thread Topology Monitor available please ? Or is there something that talk about how the scan is done ? 
 Thank you

Jørgen Holmefjord · Accepted Answer

Hi, 
 I will check internally if there is any plans to release the source code, or if it would be possible to make the scanning/topology build procedure available in this post. 
 The software use a Thread CLI node to talk to the network, through a UART interface. You can use the following commands to scan/list devices and build your network: 
 
 scan 
 child list/table 
 router list/table 
 neighbor list/table 
 leaderdata 
 
 Might be some more useful commands, please read the whole list to see what you find useful! 
 Best regards, Jørgen

Jørgen Holmefjord · Answer

There is currently no plans to release the source code of Thread Topoloy Monitor. 
 This is the commands used for scanning: 
 From CLI point of view, those commands are called inside: 
 Configuration: 
 
 panid 0xXXXX 
 channel XX 
 masterkey XX 
 ifconfig up 
 thread start 
 state // check if we are router or leader 
 state router // if not

Polling (called with specified interval): router list // get RLOC16 of all routers in the network 
 For each Router: networkdiagnostic get ROUTER_RLOC 0 1 5 6 16 // Those numbers indicate that we want to obtain e.g. child table, router table etc.

nRF Thread Topology Monitor source code

Top Replies