nRF52840 and MQTT-SNGateway example

[Jon Hoffman]

I am trying to work through the MQTT-SN Examples that comes with the Thread SDK.  When I use the prebuilt image for the Raspberry PI 3 board everything works great however I would like to setup the router on a BeagleBone Black from scratch.  

To build this I went through the border router setup from the openthread site (https://openthread.io/guides/border-router/build  ).  I also went through the MQTT-SNGateway installation from the Eclipse Github page (https://github.com/eclipse/paho.mqtt-sn.embedded-c/tree/master/MQTTSNGateway ).  I configured the gateway with the same settings as from the prebuilt Raspberry PI image.  Once everything is setup and running the MQTTSN publisher is unable to find the gateway (using the JLinkRTTClient to watch what is happening) so I think I am missing something.  I am able to ping one dev board from the other so they can communicate.  

Is there a page that walks you through the steps that Nordic used to configure the prebuilt Raspberry Pi image? 

Thanks,

[haakonsh]

Is this Thread Border Router documentation what you're looking for?

[Jon Hoffman]

As a added note, I downloaded the image from here:  https://www.nordicsemi.com/eng/nordic/Products/nRF5-SDK-for-Thread-and-Zigbee/RaspPi-Thread-Border-Router-Demo/60502  and that is the setup I would like to mirror on the BeagleBone Black

[haakonsh]

All I know is that the 1.0.0-1.alpha is built from https://github.com/openthread/borderrouter and that the previous versions are built from https://github.com/NordicPlayground/thread_border_router. 

You might get a better answer if you open an issue in the openthread border router repo.