Dear Support,
We are in pre-certification phase with our product using nRF52840.
For RF testing purposes, our testing house asked us to provide the following, and I am hoping you can offer support:
1. The Annex E form filled out ( for ETSI EN 300328)
2. The Test FW should enable the following :
We need Mark2 with active BT in the following test modes:
- Frequency hopping mode:
1) normal operation (hopping) and the equipment is assumed to have no blacklisted frequencies (operating on all hopping positions),
2) two operating (hopping) frequencies randomly selected from the operating frequencies used by the equipment. The first (lower) frequency shall be randomly selected within the range 2 400 MHz to 2 442 MHz while the second (higher) frequency shall be randomly selected within the range 2 442 MHz to 2 483,5 MHz. The equipment shall be in a normal operating (hopping) mode.
3) two adjacent hopping frequencies.
- Disabled hopping – single hopping frequency (fixed channel): the lowest and the highest hopping frequency of the band.
We need information about the BT antenna. Is it possible to provide a temporary RF connector, in the same way as it’s done with the 868 MHz RF module?
Please fill in the application form that we sent you (Annex E from ETSI EN 300 328 V2.1.1).
Thank you in advance,
Anca
