This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

LSM9DS1 header files for NRF52840

Hello Everyone ,

By using sdk version 15 for NRF52840 I wish to connect the lsm9ds1 sensor to it and using seggar embedded studios IDE. The header files available in google are using C++ configurations. And seggar is throwing a lot of compilation errors. Can someone help me in using them.

Parents

0 Einar Thorsrud over 6 years ago

Hi,

Nordic does not officially support C++ with SES, but it is supported by most tools (Including Segger Embedded Studio) so it should be possible to make it work. In any case you have to adapt the driver you have found to the nRF platform and SDK. You would at least have to adapt it so that it uses the SPI or TWI driver from the SDK to handle the low level communication with the LSM9DS1.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Einar Thorsrud over 6 years ago

Hi,

Nordic does not officially support C++ with SES, but it is supported by most tools (Including Segger Embedded Studio) so it should be possible to make it work. In any case you have to adapt the driver you have found to the nRF platform and SDK. You would at least have to adapt it so that it uses the SPI or TWI driver from the SDK to handle the low level communication with the LSM9DS1.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data