Attachments (0)
Nordic Case Info
  • Case ID: 103871
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NRF2402 pad

Sergei

Hello, I am creating a PCB design for NRF2402AG but I'm not sure whether I should connect pad under the NRF to the ground or I should left them isolated. I could not found any information about in the data sheet. Thanks.

  • 0

    On the nRF2402 it is recommended not to solder the bottom die pad to the PCB ground. This is to prevent noise from entering the chip through GND.

Terms of service