BLE MESH: Messaging from server 0x107, 0x108, 0x109 etc to Client

[Arya]

Hi,

How can I send message from servers other than 0x105 and 0x106 to client?

I receive status message in client from servers 0x105 and 0x106.

I can send message to client from the servers 0x105 and 0x106.

But I can't do this using other servers such as 0x107, 0x108, 0x109 etc.

How do I enable that?

[tesc]

Hi,

What example are you building on, or is this a custom project?

In general, you need to design your setup so that there are corresponding client and server models, and then you must configure the nodes such that they publish and listen to the right addresses and such that the same application key is bound to the model in each end. Configuration is done by the provisioner.

Regards,
Terje

[Arya]

Hi Terje,

I am working on light switch example. In simple on off model. I don't know how to adjust node_setup.c so that client will get messages send by all servers (when there is more servers like 50 of them). Like first two clients.

Thank you.

[tesc]

Hi,

What version of the nRF5 SDK for Mesh are you using? v2.1.1?

Regards,
Terje

[Arya]

Hi, I am using 2.0.1.