Custom Board makes high current in BLE Example

[Alan Ajit]

Dear Nordic,

We have a custom board and we just flashing BLE central peripheral example on it's 

works fine but when i test its current consumption its shows around 1.5 Ampere 

I need some help to reduce the current consumption

[Jørgen Holmefjord]

• Which exact example are you running on the board?
• Is the current lower if you run it on a Nordic DK?
• Which SDK version are you using?

[Alan Ajit]

That's some soldering issue its now 1 mA in Advertising time and 8 mA in Scanning time 

I think both this are little high i want to reduce maximum current 

In my application is from ble central and peripheral(relay) but i controlled its advertising and scanning 

and also i used UART,ADC and gpio in application 

I need some advise to reduce maximum current

SDK 15 used