EnOcean Switch Translator Client Demo not working

[supershirobon]

Hello all,

I have an ESRPB switch from EnOcean which uses the PTM215B transmitter internally.

I've factory reset the switch to its default state and have confirmed that the "Disable Radio Commissioning" flag is indeed set to 0 by reading the NFC tag data of the switch, so the switch is functioning properly.

However, when I perform the sequence on the switch to put it into commissioning mode, the long-short-long sequence, the translator client does nothing in response; nothing is output to the RTT logger and the LEDs don't blink as described in the documentation for the example.

Are there confirmed issues with the EnOcean demo? I have tried with Mesh versions 2.1.1 and 2.2.0.

Thanks.

[Joakim Jakobsen]

Hi.

It seems you already found and commented on this similar case:
https://devzone.nordicsemi.com/f/nordic-q-a/39578/enocean-switch-demo

At the time of writing, the thread above is still ongoing and my colleague Bjørn is looking into it.
I suggest you follow the progression of that thread and see if you get a solution from there.

If the thread above isn't helpful for you, please let me know.

Best regards,
Joakim.

[supershirobon]

It turns out it was indeed a firmware error on EnOcean's side, the Nordic example now works.