Mesh UART coexistence example not working

[kamlesh]

Hello Nordic Support Team

I am working with nrf52832 dk board.I am using mesh sdk version 2.2.0 with nrf sdk version 15.0.0.I am working with uart coexistence example i successfully integrate mesh sdk with nrf sdk and uart coexistence example successfully build without any error. 

But when i try to run uart coexistence example it stuck and fatal error occurred and i am not able to connect to uart port through nrf toolbox app.and i think due to this error provisioner not configure and adding uart coexistence client into mesh network. 

Please help me for this.

Thanks

[Mttrinh]

Hi,

You should add the define DEBUG in your Preprocessor(Project -> Edit Options -> Preprocessor -> Preprocessor Definitions), then add a breakpoint on app_error_fault_handler() to see which error you get.

[tmwinjy]

Hi. I am getting the exact same error. It is a NRF_ERROR_NO_MEM when the UART tries to initialize/advertise. This is the base version with no modifications so why does this occur?

[Mttrinh]

Hi,

This should't happen with the base example found in the SDK. Could you try downloading a fresh copy of the SDKs and try again? Which board are you using?

[tmwinjy]

I am using a Thingy52 IoT sensor kit. The issue occurs even when I follow the steps with fresh code.

[Mttrinh]

Which function is returning NRF_ERROR_NO_MEM?