Downloaded the SDK for the nRF52840 and found out that all refer to other hardware pca10040 and pca10056

[jean-marc]

Again!!! I have a lot of problems to navigate on the Nordic products.

I follow the links and went to the start52840dongle and downloaded the SDK.

I find only stuff regarding the pca10040 and pca10056, they must be kidding because the dongle is pca10059.

I would like to know which is the dongle SDK and where to find it.

I like to know what fw runs now on my Dongle if I need to reload it. I am mostly using Connect (which is very poor as compare to Master Control Panel). Or is Connect able to reflash my dongle?

How can we run Master Control Panel with this dongle nRF52840? My original Dongle pca10000 does not connect with MCS (as well as the nRF52840).

Thank you for some help.

jean-marc

[awneil]

jean-marc said:

I find only stuff regarding the pca10040 and pca10056

These are the Development boards - as the name suggests, it is expected that you will use a development board for developing on.

The development boards are a far more convenient platform for starting out and for development - not least because of the on-board J-Link.

I would strongly suggest that you use a Dev Board while you gain familiarity - and move on to the dongle later.