I have a new nRF52840 Dongle which seems to have either had a hardware failure while updating its bootloader or the updating was unsuccessful and now the device does not flash the red led, what can I do to update the bootloader or test the hardware?
I have a new nRF52840 Dongle which seems to have either had a hardware failure while updating its bootloader or the updating was unsuccessful and now the device does not flash the red led, what can I do to update the bootloader or test the hardware?
Hi,
I got the same issue, but it gets to blinking mode arfter pressing reset button.
Check the manual here.
Thankyou, that sorted it out
We in Tech Support have e.g. received quite a few questions
Indeed - there seems to be at least one per day on this public forum!
remember that the dongle is not the same as a DK! If you want to do a lot of development, buy a DK instead.
In light of the above, I think you should really make that clearer on the Dongle Product Page!
eg, see:
You could save yourselves a lot of work - and a lot of disappointed/frustrated customers!
would I be able to program the nRF52840 Thingy using Segger and DK, I have not checked yet but did find the problem encountered above trying to program via the USB
apparently it has the same issue, now to get a programmer for the two Nordic units I have
at least one per day on this public forum
a mere 4 hours later:
Thanks for that awneil, I will mention this internally.
Thanks for that awneil, I will mention this internally.