• State Verified Answer
  • Locked Locked
  • Replies 3 replies
  • Subscribers 67 subscribers
  • Views 1406 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 104019
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot get Heart Rate sample working

SergP

I am following nRF51822_Evaluation_Kit User_Guide v1.2.pdf (page #9) to run Heart Rate sample but I am unable to get an expected result (LED 0 should be lit) when I am pressing a Button 0, in addition, when I was trying to setup a breakpoint in the Main() - it was not hit. Note that I have SoftDevice programmed to my Evaluation Board - in nRFgo Studio I can see:

Region 0 (SoftDevice) Size: 80 kb Firmware: s110_nrf51822_6.0.0 (id:0x0049)

What could be wrong?

Parents Reply
  • 0 in reply to Petter Myhre

    Eventually you were right because I just realized that I didn't have the latest available soft device - I had version 6 but there is a version 7 available as well, once I downloaded and programmed it I am now able to see an expected behavior, thank you.

Children
No Data
Related