RED compliance

[Arepa]

Hi there,

I am about to perform an RF emission test to my product which is using a nRF52 chip and different RF sources as wifi and cellular and I was requested to:

"The radio needs the ability to operate in a single channel mode WITHOUT the need for an access point.  Often times the OEM of the radio provides special software to control this "

From my understanding referencing to BLE, I have to limit the numbers the channels for advertising(37-39) to a single channel e.g 39 and connection(0-36) to a single channel e.g 36 only for the test, in the case for advertising I know it is possible, but what about the connection channels?

Any recommendation?

I am using a thirty party nRF52832: Ublox NINA-B111 with an external antenna, SDK13, and SDK14.2 ( same project under both SDK versions)

Regards,

Arepa

[Andreas]

Hi,

 

You can use our 'radio test example' for this, shipped with the SDK. See the documentation on how to use it here. Using this, the test house will be able to configure it as they need for the tests.

 

Best regards,

Andreas

[Arepa]

Hi Andreas

When you said I can use your radio test example, it means I can use it instead of my own application for the RF test?

if so that is great

[Andreas]

Hi,

 

Yes, the testing can be done with this instead of your own application. Just load the pre-compiled hex, or customize the code as you like, and you are good to go.

 

Best regards,

Andreas