How to use Serialization for nRF mesh SDK with peripheral drivers and any example available for serialization in mesh?

[Sash]

I want to use application board and connectivity board with mesh sdk in nordic chip. Is there serialization is available for mesh like using in nRF SDK15.0.0 peripheral driver. I have seen examples in mesh sdk as serial. Is that used for serialization or it is just used as model.

[Mttrinh]

Hi,

We do not have that type of serialization example available for Mesh, you can read more about the serial example found in the Mesh SDK here.

[Mttrinh]

The serial example implements the serial interface for the mesh stack. You can flash the serial example on one board then use Interactive PyACI to interactively control the device running the mesh stack and the serial interface. Go through Interactive mesh provisioning and configuration, it show you how to use the serial interface to provision and configure a mesh network. 

I'm not sure if this is what you want/looking for, but hope it is more clear regarding the serial example.