• State Verified Answer
  • Replies 2 replies
  • Subscribers 67 subscribers
  • Views 1373 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 104116
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

Accessing GPIO pins in nRF51 beacons

Abdelraouf

We have some nRF51 beacons kits and we want to connect some external peripherals using the available GPIO pins.

Does any one have an idea on how to solder some pin headers ? Or is it possible to solder a wire directly ?

Suggestions are most welcome .. and thanks a lot for your help!

Parents
  • 0

    I would just use a thin wire to solder directly on to the pad. If you plan on using the same beacon board to connect/disconnect to several sensors I would solder the wire to a header and then have the wire between beacon board and the header the same and change the sensor input on the header.

    Anyways, there's no problem with soldering on a thin wire directly on the beacon kit.

Reply
  • 0

    I would just use a thin wire to solder directly on to the pad. If you plan on using the same beacon board to connect/disconnect to several sensors I would solder the wire to a header and then have the wire between beacon board and the header the same and change the sensor input on the header.

    Anyways, there's no problem with soldering on a thin wire directly on the beacon kit.

Children
Related