What's the difference from running mesh sdk on SES to on board?

[zzzh]

Hi，

I'm  doing a rssi detect test based on nordic mesh sdk 2.2, it runs well when connect to a computer running SES by j-link, but almost don't work when running on board itself.

Any ideas on what's going on?

[run_ar]

Can you please elaborate on what it is you are doing?

If it only work when you have connected a debugger I would guess your application would be sleeping when the the debugger is not connected. which is why it "almost works", not sure what "alomst works" means, though...

[zzzh]

I'm sure it's not sleeping.

It looks like there's big difference in the rssi value it detceted.

[run_ar]

ok, so what board are you using to measure RSSI? is it located and oriented in the exact same way when it is connected to the pc and when it is not? What is the variation in RSSI measurements you are seeing?