• State Not Answered
  • Replies 3 replies
  • Subscribers 67 subscribers
  • Views 24334 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 104186
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nrf24l01+ IRQ current in between retries

debraj

Could you please let me know the current rating in between retries while transmitting.From the oscilloscope reading, that is not obvious. The documentation shows three idle modes.

  1. power down mode: 900 nA
  2. standby I mode : 26 uA
  3. standby II mode : 320 uA

This are required for my research to accurately calculate the current consumptions.

Parents
  • 0

    In documentation, it also refers to the section with ART:

    "nRF24L01+ enters standby-I mode if there is no more untransmitted data in the TX FIFO and the CE pin is low. If the ACK packet is not received, nRF24L01 goes back to TX mode after a delay defined by ARD and retransmits the data. This continues until acknowledgment is received, or the maximum number of retransmits is reached."

Reply
  • 0

    In documentation, it also refers to the section with ART:

    "nRF24L01+ enters standby-I mode if there is no more untransmitted data in the TX FIFO and the CE pin is low. If the ACK packet is not received, nRF24L01 goes back to TX mode after a delay defined by ARD and retransmits the data. This continues until acknowledgment is received, or the maximum number of retransmits is reached."

Children
No Data
Related