This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

how to run timer 2 along with softdevice in nrf51822?

Hi

I am using nrf51822 qfac , custom board.

Specification of board as follows.

Crystals 16MHz and 32 KHz

softdevice S130

SDK 11

In my application I need to configure timer 2 and timer 0 which is for softdevice.  I read that timer 2 and timer 0 are independent but I am not able to find way to start both of them at time.

 on independent projects both timers are working fine, but if I used in same project then device fails to advertise and get reset every time.

Is there any example or document which can help me in this problem?

Thank you.

Related