Good morning!
First of all, the background. I made a custom board and programmed it, everything worked like a charm. After that, I made another one, same hardware, same software, same design, same components, same method, same everything, however this one is not being detected by nrfGO. It detects the nrf52DK, as if there was no custom board connected at all.
At first I thought: human error. I always use ESD protection when soldering. I checked all the components several times. My question, is there a way to know for sure that the MCU is not corrupted? Any pin that should output a square signal or something similar to that?
Thank you in advance!
AGB
