Is there any method to hide advertise packet from nRF52 in the nRF Connect utils?

Question

We want to use some device in the peripherial mode. 
 after the devices were bonded, for next connect I need to hide this advertise packet from air in the nRF Connect util. Is it possible? 
 I can hide name- works. 
 Also I tryed (after has bonded) change 
 BLE_GAP_ADV_FLAGS_LE_ONLY_GENERAL_DISC_MODE 
 to 
 BLE_GAP_ADV_FLAGS_LE_ONLY_LIMITED_DISC_MODE 
 At this case, there is no any device in the nRF connect but also can't connect to bonded device.

Stefan Wyss · Answer

I'm a absolute beginner, but maybe I can still give you some advice based on what I found on this forum: 
 Basically all advertisements are visible to all scanners . But the scanners can assume that: 
 
 if the Limited discoverable mode is used the device will only advertise for a limited amount of time. e.g. the user has put the device in bondable mode or some other time limited mode. 
 If a scanner sees a "non discoverable" advertisement it can assume this device uses a whitelist or for some other reason is not connectable. So it can save power by not trying to connect. 
 But I'm afraid the behavior will depend on the implementation, as it's up to the developer to use these flags correctly. Unless you are implementing a sig define profile with given requirements for flags.