This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Problem while drag and drop hex file to mbed usb drive

I have compiled my mbed program and hex file has been downloaded but I am unable to drag and drop my hex file to mbed USB drive. It is saying Not Ejected properly. I tried to eject properly and turned it off and again turned ON but still didn't worked. Can you please help. I am new to this board.

Parents

0 Stian Røed Hafskjold over 9 years ago

Are you sure the file doesn't get uploaded? In a thread on the mbed forum, they say it is expected behaviour, and that the file will get flashed anyway. developer.mbed.org/.../ So, if it doesn't work I suspect something else must be wrong.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Stian Røed Hafskjold over 9 years ago

Are you sure the file doesn't get uploaded? In a thread on the mbed forum, they say it is expected behaviour, and that the file will get flashed anyway. developer.mbed.org/.../ So, if it doesn't work I suspect something else must be wrong.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data