Board Did not detected

[Alan Ajit]

Hi  Nordic.

currently i am  working on nRF52840 as a reader and after designing as per your recomendation and it is ready to check but whe i connected to the commander the board is not detecting .so i decided to check the voltage of nrf52840 donngle and my board ,all the voltages were same in both 2 boards except VDD_nRF i got around 2.5v where my power in is 3.3v .is that the issue of my problem described above.? Because all other schematic and pcb is excactly same as please help me by clearing my doubts.

Thanks.

[Hung Bui]

Hi Alan, 

Could you describe a little bit more on "when i connected to the commander the board is not detecting". What did you mean by commander ? 

Do you have any programmer connect to the SWD interface of the board ? Please be aware that the chip comes without any bootloader so you would need to have a programmer to program the chip. 

How do you provide power to VDD_nRF ? 

Please share your schematic , layout and a close up photo of your board. You can convert this thread to private by click "Go Private"