This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

not running application

i try to test Low Energy Applications Using nRF51822 with application note ( nAN-36 )

in chapter 4 : led button example, build and install success~!, but, not running application. so, i download source code from github, however, same result.

normally, keil compiler show log Erase Done. Programming Done Verify OK. Application running...

but application note's app shows log without "application running..."

what is need to setting param in keil IDE?

response to me~!

Thank you~!

0 Asbjørn over 9 years ago

Did you program the softdevice into the chip as well? The led button example will be installed above the softdevice in flash and if the softdevice isn't there, your code will not start.
Cancel
Vote Up 0 Vote Down

Cancel
0 Stian Røed Hafskjold over 9 years ago

Which SDK version are you using? Did you see the fix for SDK 6.0.0 on GitHub? github.com/.../SDK6.0

You wrote: "but application note's app shows log without "application running..." "

Is you problem that the application does not run at all? Or are you wondering why the log in the application note does not contain "Application running"? In the last case, it's because it is run in debug mode (Ctrl + F5)
Cancel
Vote Up 0 Vote Down

Cancel