I am trying to do the segger development for the 9160 lte ble gateway. When I do the setup info for segger I keep getting a popup saying it can't find the .emproject file. I don't see an emproject file in any of the samples?
I am trying to do the segger development for the 9160 lte ble gateway. When I do the setup info for segger I keep getting a popup saying it can't find the .emproject file. I don't see an emproject file in any of the samples?
Hi.
Which version of Segger are you using? Have you done the nRF Connect Getting Started Assistant?
Best regards,
Andreas
Hi Andreas,
Yes, I completed the getting started assistant. I was able to connect to my board and get the "gps" signal and I can flip the switch and see it change status in the RFcloud. I am using 64-bin Segger v4.14.
Hi.
So you are not getting this "pop-up" anymore? If you are getting it, could you share a screenshot of it?
Best regards,
Andreas
Am seeing the same issue as wischmi2. My setup is MAC OSX 10.14.2, Segger 4.14.
Yes, I’m still getting the pop up similar to what wesaymorning posted.