• State Verified Answer
  • +1 person also asked this people also asked this
  • Replies 7 replies
  • Subscribers 76 subscribers
  • Views 3377 views
  • Users 0 members are here
Attachments (0)
Nordic Case Info
  • Case ID: 223293
Options
This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

asset_tracker.emProject is reported invalid

craig.goldman

I am running on a Windows 10 PC.

I've downloaded and installed all the tools for the nRF9160 DK using nRF Connect.

After installing the Segger Embedded Studio, I followed the instructions for "Open nRF Connect SDK Project" and I got a message stating ".../ncs/nrf/samples/nrf9160/asset_tracker/build/asset_trcker.emProject is invalid.  The reported error is 'solution load command failed (1)'

Parents
  • 0

    I found the problem.

    The configured board directory was "nrf9160_pca1009", instead of "nrf9160_pca10090".  Likely one of my copy and paste operations failed to copy all the text.  Not sure why that mistake caused the above error message.   My advice to anyone getting a similar error message is to re-check all of the directory paths.

    Thank you to all that offered help.

    -Craig Goldman

Reply
  • 0

    I found the problem.

    The configured board directory was "nrf9160_pca1009", instead of "nrf9160_pca10090".  Likely one of my copy and paste operations failed to copy all the text.  Not sure why that mistake caused the above error message.   My advice to anyone getting a similar error message is to re-check all of the directory paths.

    Thank you to all that offered help.

    -Craig Goldman

Children
No Data
Related
Terms of service