nRF9160 DK GPIO-UART

[Hoang]

Dear, 

I am using nRF9160 DK, I want to use nRF9160 SIP to connect with another sensor ( UART /SPI) 

Do you have any suggestions or examples?

Thanks,

Rgards

hng

[cdugue]

Hi, I am having a similar issue. I setup the nRf9160 with the UART sample and I get some characters when I type in one of the serial port. However, the data received appear to be only 0 or 128 if I print the decimal value in the UART CB. Any ideas on what could be the issue? Thanks.

Regards,

Corentn

[Håkon Alseth]

If you have setup the example as being discussed in this thread, you should send data in one COM port, while the other should print it.

It is a loopback of UART1 over the UART0 interface.

 

If you have a different setup than what is discussed in this thread, I would recommend that you start a new thread.

 

Kind regards,

Håkon