Dear,
I am using nRF9160 DK, I want to use nRF9160 SIP to connect with another sensor ( UART /SPI)
Do you have any suggestions or examples?
Thanks,
Rgards
hng
Dear,
I am using nRF9160 DK, I want to use nRF9160 SIP to connect with another sensor ( UART /SPI)
Do you have any suggestions or examples?
Thanks,
Rgards
hng
Hi,
That is strange. The only difference at my end is that I am using a .overlay file, but that should not have any impact, as its set in the main dts file.
Here's my .hex file, could you check if this one works at your end?
If that one does not work, it might be due to the nRF52 board controller firmware not being present. This can be downloaded from here (remember to switch SW5 into nRF52 position, and back again after programming):
https://www.nordicsemi.com/Software-and-Tools/Development-Kits/nRF9160-DK/Download#infotabs
*edit* race condition... You've already fixed the issue :)
Kind regards,
Håkon