interfacing of kiel with nrf52 dk

[krishna94]

hello,
i am complete beginner to this field of MCU, i never worked on nordic MCUs. i am able to program the dk-board using the usb cable and readymade hex file provided in nordic SDK. i am unable to setup the kiel to program my dk board. i have installed the softdevice using nrfstudio.  after importing the inbuilt program blinky from SDK in kiel i built, it was successfully built with zero errors but whille dowloading the programusing kiel it gives me an error (shown in the picture).  can someone please guide me step by step to setup kiel to interface with nrf52 dk board.

thanks

[Simonr]

Hi

It sounds like your Segger driver for Keil is not properly installed. Try (re)installing the Segger drivers.

If you are completely new however I suggest you try SEGGER Embedded Studio (SES), as this is a free IDE for Nordic Semiconductor customers, and I personally find it as an easier development environment than Keil (Of course if you are already comfortable with using Keil, never mind).

Best regards,

Simon

[krishna94]

thank you for the reply, i reinstalled the segger rivers and i am able to program via SES but only through the onbaord debuger, when i try to load program via eternal j-link debugger it shows me this error 
no target detected