No command complete event received

[nullpointer]

I got this error when programming the Development Dongle. The dongle is recognized in the
Master Control Panel as a COM4 - xxxx, and when is connected a green led and blue led are ON

Firmware: MEFW nRF51822 0.10.0 UART baud rate: 1000000 bps

Master Control Panel 3.7.0.8517

log.txt

[David Edwin]

Looking at the screenshot it is clear that the master control panel cannot see the board with the correct firmware. Is the board really located at COM5 in the virtualbox ? Has it been flashed with the correct hex file ?

Ensure that you have made the USB port available to virtual box so that windows can see the USB port. Ensure that the device manager on windows recognizes the board and loads a COM port driver (CDC) for it and a jlink driver for it. Flash the firmware for master control panel to the board File -> Flash programming. Point the master control panel at the right COM port.

Let me know how it does.

[David Edwin]

Can you ensure that the nRFgo Studio is not running when the Master Control panel is running . Now we need to verify that the MEFW was correctly flashed to the dongle.Can you give me a screen shot of the nRFgo Studio with the MEFW flashed into the dongle. Click on the dongle when you do the screen shot.

I would also like a screen shot of the USB port being assigned to the Windows OS by virtual box and any options that come with it.