SEGGER emStudio build project failure

[Samuel]

Hi,

After trying to work out why one of our nrf9160 DK:s cannot execute any AT commands using the at_client sample I tried redoing the getting started guide to make sure it is purely a problem with the board. After doing that SEGGER emStudio stopped working and when I try to build a project I get the following error:

This is the same for all samples and I can't figure out why, how can I fix this?

Kind regards 

Samuel

[Samuel]

I have 7-2018-q2-update as suggested in the getting started guide, it is not the latest version. Is that the one you mean or is it a 2017 release that must be used?

[Gurkan]

Sorry my bad I meant 2018, I still cannot accept that we are in 2019
Have you tried to build it with command prompt?

And before building can you check variables are set right by 

echo %ZEPHYR_BASE%
c:\Nordic\ncs\zephyr\

echo %ZEPHYR_TOOLCHAIN_VARIANT%
gnuarmemb

echo %GNUARMEMB_TOOLCHAIN_PATH%
C:\gnuarmemb

mkdir build & cd build
cmake -DBOARD=nrf9160_pca10090 -GNinja ..

[Samuel]

Yes I tried it. Verified variables:

And then the build:

So it seem to be the same error for building via cmd as well

[Gurkan]

While verifying the variables you only need to run the command as "echo %ZEPHYR_BASE%" and the output should point your folder regarding with variable. in your case it should be "C:/Users/sjonsson2/new_git/ncs/zephyr"

By the way before doing you need to run "zephyr-env.cmd" in your zephyr folder. That script will setup your variables

[Samuel]

After checking and verifying my variables and changing my folder name for my new install it works. When running cmake it was looking for files in a path that didn't exist anymore (It did not look in the path specified in the variables for some reason but got the old path). So I just renamed my folder to the old name.

Anyway it works now, thank you for your help!