Hello,
I try to use the S310 V2 but got stuck into problems.
in order to start the application from bootloader in the S310 V1 I did succesfully :
void (*application)(void);
sd_softdevice_disable();
sd_softdevice_forward_to_application();
/* Jump to user application */
uint32_t application_pc = *(__IO uint32_t*)(application_start_address + 4);
application = (void (*)(void))application_pc;
/* Initialize user application's Stack Pointer */
__set_MSP(*(__IO uint32_t*) application_start_address);
application();
now in S310 V2 I replace the forward_to_application by the new command:
sd_softdevice_vector_table_base_set(application_start_address);
now even in the sd_softdevice_disable(); (as well as sd_softdevice_vector_table_base_set) the processor stucks in the SVC call. Initially I did not enable the sd. Do I have to do that? I am not using any service?
I checked also the reference here: devzone.nordicsemi.com/.../ but this was no help for me.
I programmed the softdevice using:
nrfjprog --programs softdevice.hex --dfu as well as
nrfjprog --programs softdevice.hex
but with no luck.
Thx for any help.
Regards, Adib.
