This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't get Keil to break at Main

I have a custom board utilizing an RF51822aa device. To test connectivity to the board I built blinky_s110_pca10028. Using Keil 5.12 I tried to debug the program simply expecting to break in main thus verify I can talk to the M0 on the RF51822. My setup uses, as i mention 5.12 and Keil's ULINK2. When I start debug I can see the download occur, then Keil opens a Disassembly window.

I was expecting to have main.c opened and a break point hit. Instead, I have the Disassembly window open and a pointer to address 0x000114CC. Not sure what address that is.

Any thoughts?

Top Replies

Parents

0 John over 10 years ago

Did you program the soft device executable onto your board before programming and attempting to debug the example? I've seen the behavior you describe when I've forgotten to program the soft device onto a newly built custom board.

Reply

0 John over 10 years ago

Did you program the soft device executable onto your board before programming and attempting to debug the example? I've seen the behavior you describe when I've forgotten to program the soft device onto a newly built custom board.

Children

No Data