nrf52 Battery Measurement 4*AA batteries

[Bilal]

Hello,

I need to measure battery on my nrf52 beacon. My input voltage is 4*AA batteries(each 1.2V so in total 4.8V). The schematic provided by the hardware developer is as follows

Now I read few posts about battery measurements and looks like I need to add some additional hardware? Kindly tell me whether its possible to measure voltage using existing hardware, if so please describe, the calculations or at least point me to the right direction.

Thank You

Regards

Bilal

[awneil]

Bilal said:

I read few posts about battery measurements and looks like I need to add some additional hardware

Yes - that should be clear from those posts!

Surely, this is something that your hardware developer should be doing? It is a hardware question!

[Bilal]

I think it involves both, hardware and software. As far as I know , there must be some kind of voltage regulator used to bring down voltage to 3V. Can we use that to do our battery measurements?

[awneil]

Of course - the whole thing involves both!

But it should be the hardware designer's job to feed an appropriate signal to a pin on the chip.

You need a voltage divider - not a regulator.

[cbd]

I agree with awneil.

I see on your circuit diagram that you are running your nRF52 at 3.3V.

Although you can run the nRF52 on more than 3.3V, you can only allow an input to be 0.3V above that.

If you wish to detect the battery voltage directly then you will need a divider of sorts to step down the voltage, but these tend to impose their own problems due to leakage currents.

These are all points that your hardware engineer should take into account.

So you may look at measuring a voltage that has a maximum of 2.4V say and then internally calculate that as 4.8V

Alternatively you may wish to just measure the voltage on the MCU supply line using one of your Analogue Inputs (AIN#), but that will limit your maximum value to 3.3V.

[Bilal]

Thank You @cbd and @awneil.  So i just checked, apparently we have a voltage divider having R1 = 470k, R2 = 110k and capacitor = 1nf, we also feed the output to AIN7. So do we need to just start the adc pin and start sampling with configuration NRF_ADC_CONFIG_REF_VBG   ?