Problem using digital IO as MISO.

[Luccas]

Hi, I'm trying to set P0.20 pin as MISO of my spi master to communicate with ADXL372 accelerometer sensor, but when the miso is disconnected the signal received matches with expected and when connected to the DK pin the signal is modified and results are different. 

The expected signal received when disconnected from DK: 

The received signal after connected to P0.20 pin:

I used the default configuration of SPI:

nrf_drv_spi_config_t spi_config = NRF_DRV_SPI_DEFAULT_CONFIG;

spi_config.frequency = NRF_DRV_SPI_FREQ_4M;
spi_config.ss_pin = SPI_SS_PIN; //P0.08;
spi_config.miso_pin = 20;
spi_config.mosi_pin = SPI_MOSI_PIN; //P0.16;
spi_config.sck_pin = SPI_SCK_PIN; //P0.16;
spi_config.mode = NRF_DRV_SPI_MODE_0;


uint32_t ret =nrf_drv_spi_init(&spi, &spi_config, NULL , NULL);

I've already tried to change the MISO pull config on sdk_config.h with no success.

NRFX_SPIM_MISO_PULL_CFG 1

I'm using SDK 15.2.0_9412b96 on PCA10040 V1.1.1 2016.35, with softdevice  s132 6.1.0.

Do you know how can I configure this pin to work properly? 

[awneil]

Have you checked the PCA10040 schematics to see if there's anything else connected to that pin ... ?

[Luccas]

Yes, It has the LED4 connected, I've already cut the SB8 connection to disable the LED. 

[haakonsh]

Have you tried using another pin? That pin's trace might have to much capacitance to be used for SPI. 

[Luccas]

Yes, I've tried another digital pin with same results. Using AIN pin worked, but I dont know why. 

[haakonsh]

Serial interfaces can behave a bit strangely when using jumper wires between devices. The problem almost always goes away once you get both device on the same board. For now I suggest you try different I/O pins and use whatever works.

[Luccas]

Haakonsh thanks for your support!

Actually I've also used the sensor and the nrf52 on our developed integrated board and the results were the same. I've accidentally discovered one solution, inserting some resistance(like 100 ohms) between the nrf pin and the sensor pin solved this strange behavior. Not sure why. 

I've already used others sensors without this problem, so this must be something with this sensor. 

[haakonsh]

That's strange how a 100ohm series resistor fixed the issue. 
Anyways I'm glad you fixed your problem, SPI can be a real b**** to debug xD