AT Host example does not respond

[jlienau03]

Hello,

I am having difficulty getting the AT Host operating on the DK.  I have DK version 0.8.5 and updated my libraries from github (in anticipating of evaluating the GPS).  Anyway, after I program the DK with the AT Host example, all my AT commands appear to timeout.  Here are the steps I take:

1. Build and program the SPM example onto the DK.
2. Build and program the AT Host example onto the DK.
3. Open up nRF Connect, open the comm port, and press the reset button on the DK.
4. Attempt to enter the AT+CFUN? and AT+CFUN=1 commands.  Below is a picture of my error.

Also, FYI, when I am importing the nRF Connect project I am not using the 'ns' version for the Board Name.

[GNotman]

I had an issue with the exact same example where SES was not uploading the correct (combined) output file.

The verified answer here helped me:

https://devzone.nordicsemi.com/f/nordic-q-a/47032/mqtt_simple-programmed-to-wrong-address-range-00008000----00020abb/185854#185854

[jlienau03]

This worked! Thank you!